Ignition Lock Cylinder

Fig. 1 Ignition Lock Installation:

WARNING:
On models equipped with Airbags, Refer to Air Bags (Supplemental Restraint Systems)/ Service and Repair / Disarming procedures before performing any repair. Service and Repair

1. Remove steering wheel.
2. Remove turn signal switch.
3. Place ignition switch in Run position, then remove lock cylinder retaining screw and lock cylinder.
4. Install by rotating lock cylinder to stop while holding housing, Fig. 1. Align cylinder key with keyway in housing, then push lock cylinder assembly into housing until fully seated.
5. Install lock cylinder retaining screw.
6. Install buzzer switch, turn signal switch and steering wheel.
7. Rearm airbag.