First Design Seat Back
REMOVAL PROCEDURESeat Back Panel Replacement (Front) First Design Seat Back: Removal Procedure:
1. Remove the front seat.
2. Remove the lumbar support actuator knobs. Use a small screwdriver to pry the knobs off.
3. Remove the front seat cushion outer finish panel.
4. Remove the front seat cushion inner finish panel by unsnapping.
5. Remove the seatback map storage panel screws.
6. Remove the front seatback map storage pocket and panel by disengaging tabs to release.
Remove the front seatback map storage pocket and panel by disengaging tabs to release.
Seat Back Panel Replacement (Front) First Design Seat Back: Removal Procedure:
7. Remove the seatback map storage pocket screws.
INSTALLATION PROCEDURE
Seat Back Panel Replacement (Front) First Design Seat Back: Installation Procedure:
1. Install the front seatback map storage pocket.
2. Install the front seatback map storage pocket screws.
Tighten
Tighten the front seatback map storage pocket screws until fully seated and not stripped.
Seat Back Panel Replacement (Front) First Design Seat Back: Installation Procedure:
3. Install the front seatback map storage pocket and panel.
Install the front seatback map storage pocket and panel by engaging tabs to secure in place.
4. Install the front seatback map storage pocket panel screws.
Tighten
Tighten the front seatback map storage pocket panel screws until fully seated and not stripped.
5. Install the front seat cushion inner finish panel by snapping on.
Install the front seat cushion outer finish panel.
6. Install the Lumbar support actuator knobs. Grasp knob and push inward to secure.
7. Install the front seat.