Installation

1. Remove the masking from the plenum ports.
2. Install the intake plenum O-rings.
3. Install the intake plenum.
4. Ensure the guide pins are accurately aligned.
5. Install the crankcase vent tube adapter to the intake plenum.





6. Install the crankcase vent tube adapter screw. Tighten the crankcase vent tube adapter screw to 8 Nm (71 inch lbs.).





7. Install the throttle body to the intake plenum.





8. Install the throttle body bolts. Tighten the throttle body bolts to 12 Nm (106 inch lbs.).
9. Install the intake plenum bolts. Tighten the intake plenum bolts to 8 Nm (71 inch lbs.).
10. Install the intake plenum caps.
11. Install the vacuum hose to the fuel pressure regulator.
12. Install the electrical connection and vacuum hose to the intake plenum switchover valve solenoid.





13. Install the wiring channel bolts (1) to intake plenum. Tighten the wiring channel bolts to 8 Nm (71 inch lbs.).
14. Install the brake booster threaded vacuum hose (2) to the intake plenum. Tighten the brake booster threaded vacuum hose until fully seated. Do no strip the brake booster threaded hose.
15. Install the Throttle Position Sensor (TPS) and Idle Air Control (IAC) electrical connection.
16. Install the accelerator cable and cruise control cable bracket.
17. Install the accelerator cable and cruise control cable bracket bolts. Tighten the accelerator cable and cruise control cable bracket bolts to 8 Nm (71 inch lbs.).
18. Install the accelerator cable to the bracket.
19. Install the accelerator cable and cruise control cable to the throttle body linkage.
20. Install the intake plenum air inlet hoses to the throttle body.
21. Install the IAC inlet hose and electrical connection.
22. Install the IAC inlet hose clamp.
23. Reconnect the negative battery cable.
24. Reprogram the applicable accessories.