Component Specifications (Front)
Front Brake Rotor: | Type | Vented | |
Diameter (Nominal) | 11.653 Inch (in) | ||
Maximum Lateral Runout (Installed) | 0.004 Inch (in) | ||
Maximum Lateral Runout (Removed) | 0.001 Inch (in) | ||
Thickness (New) | 1.102 Inch (in) | ||
Maximum Thickness Variation | 0.0005 Inch (in) | ||
Minimum Thickness After Refinish | 1.043 Inch (in) | ||
Discard Thickness All front brake rotors have a discard dimension cast in them. This is a wear dimension and not a refinish dimension. Any front brake rotor which does not meet the specification should be replaced. | 0.984 Inch (in) | ||
Rotor Refinishing Ammco(R) Brake Lathe: | Rough Cut: | Spindle Speed | 150 Rpm |
Depth of Cut (per side) | 0.006 To 0.025 Inch (in) | ||
Tool Crossfeed (per revolution) | 0.01 Inch (in) | ||
Minimum Remaining Thickness Including Lining Plate. | 0.315 Inch (in) | ||
Vibration Dampener | Yes | ||
Sand Front Brake Rotor (Swirl Pattern) | No | ||
Finish Cut: | Spindle Speed | 150 Rpm | |
Depth of Cut | 0.004 To 0.006 Inch (in) | ||
Tool Crossfeed (per revolution) | 0.002 Inch (in) | ||
Vibration Dampener | Yes | ||
Sand Front Brake Rotor (Swirl Pattern) | Yes | ||
Accuturn Brake Lathe Single Cut: | Spindle Speed | 105 Rpm | |
Depth of Cut | As Necessary | ||
Tool Crossfeed (per revolution) | 0.003 Inch (in) | ||
Vibration Dampener | Yes | ||
Sand Front Brake Rotor (Swirl Pattern) | Yes |