Vehicle Damage Warnings

WARNING: Certain components in the Antilock Brake System are not intended to be serviced individually. Attempting to remove or disconnect certain system components, may result in personal Injury and/or improper system operation.

CAUTION:
^ Always use the correct fastener in the correct location. When you replace a fastener, use ONLY the exact part number for that application. General Motors will call out those fasteners that require a replacement after removal. General Motors will also call out the fasteners that require thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors) on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and the joint clamping force, and may damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you avoid damage to parts and systems.

^ The use of rubber hoses or parts other than those specified for the Antilock Brake System (ABS) may lead to functional problems requiring major overhaul. Replace all components included in repair kits used service this system. Lubricate rubber parts with clean, fresh brake fluid to ease assembly. Do not use lubricated shop air on brake parts as damage to rubber components may result. If any hydraulic component is removed or brake line disconnected, it may be necessary to bleed all or part of the brake system. The torque values specified are for dry, unlubricated fasteners.

^ Avoid spilling brake fluid on any of the vehicle's painted surfaces, wiring, cables or electrical connectors. Brake fluid will damage paint and electrical connections. If any fluid is spilled on the vehicle, flush the area with water to lessen the damage.