Ignition Switch - Column Shift

REMOVE OR DISCONNECT





1. Disable the Supplemental Inflatable Restraint (SIR) system.
2. Negative (-) battery cable.
3. Steering column from vehicle.





4. Hex nut (85) and Torx(R) washer head (81).
5. PRNDL adjuster bracket (86).
6. Hex nut (85) and tore washer head (81).
7. Dimmer switch assembly (89) from rod (88).
8. Dimmer switch mounting stud (87).
9. Ignition switch assembly (84) from ignition switch actuator assembly (80).
10. Turn signal switch assembly (13) connector from bulkhead connector.
11. Pivot & (pulse) switch assembly (23) connector from bulkhead connector.
12. Dimmer switch connector from dimmer switch assembly (89).

INSTALL OR CONNECT

NOTICE: When fasteners are removed, always reinstall them at the same location from which they were removed. If a fastener needs to be replaced, use the correct part number fastener for that application. If the correct part number fastener is not available, a fastener of equal size and strength (or stronger) may be used. Fasteners that are not reused, and those requiring thread locking compound will be called out. The correct torque value must be used when installing fasteners that require it. If the above conditions are not followed, parts or system damage could result.

NOTICE: Ensure all fasteners are securely seated before applying needed torque. Failure to do so may result in component damage or malfunctioning of steering column.

1. Lock cylinder (20) to "OFF-LOCK" position.





NOTICE: Install ignition switch (84) to jacket (78) with switch in "OFF-LOCK" position. New ignition switch will be pinned in "OFF-LOCK" position. Remove plastic pin after switch is assembled to column. Failure to do so may cause switch damage.

^ Adjust ignition switch assembly (84).
A. Move switch slider to extreme right position.
B. Move switch slider one detent to left "OFF LOCK" position.
2. Ignition switch assembly (84) to actuator assembly (80).
3. Dimmer switch mounting stud (87).
^ Tighten stud (87) to 4.0 (35 lb in).
4. Dimmer switch assembly (89) to rod (88).
5. Hex nut (85) and Torx(R) washer head (81).
^ Tighten finger tight.





^ Adjust dimmer switch (89).
A. Place 3/32-inch drill bit in hole on switch to limit travel.
B. Position switch on column and push against dimmer switch rod (88) to remove all lash.
C. Remove drill bit.
^ Tighten nut (85) and screw (81) to 4.0 Nm (35 lb in).
6. PRNDL adjuster bracket (86).
7. Dimmer switch connector to dimmer switch assembly (89).
8. Pivot & (pulse) switch assembly (23) connector to bulkhead connector.
^ Seat connector body until securely locked in.
9. Turn signal switch assembly (13) connector to bulkhead connector.
^ Seat connector body until securely locked in.
10. Steering column to vehicle.
11. Negative (-) battery cable.





12. Do "Adjust" and "Inspect," under "INSTALL OR CONNECT," refer to INTERLOCK SOLENOID ASSEMBLY.
13. If all service operations are completed, enable the SIR system.