Axle Seals Removal and Installation

AXLE SEALS REMOVAL AND INSTALLATION 4T80-E TRANSAXLE


^ Tools Required
- J 39051-1 Right Seal Driver
- J 39051-2 Left Seal Driver





1. Using a screw driver remove the right and left axle seals (37, 125) by prying them out.





2. Using the J 39051-1 right seal driver and the J 39051-2 left seal driver, install the new axle seals (37, 125). Use the output shaft (57) to pilot the seals and the tool into the case. Ensure that the snap rings are installed on the output shaft.