Lower Control Valve Body Assembly Removal

LOWER CONTROL VALVE BODY ASSEMBLY REMOVAL 4T80-E TRANSAXLE





1. Use a small screwdriver in order to disconnect the manual valve linkage clip (915).





2. Use a small screwdriver in order to disconnect the electrical connectors from the following parts:
- The 1-2 shift solenoid valve
- The 2-3 shift solenoid valve
- The automatic transmission fluid pressure manual valve position switch
3. Remove the wire harness from the two wiring harness clips.





4. Remove the nine 10-mm bolts (534) from the oil transfer plate (956).
5. Remove the oil transfer plate (956).





6. Remove the two 10-mm nuts and the 11 10-mm bolts from the lower controls assembly. Do not remove the four bolts indicated.





7. Lift the lower channel plate, valve assembly and accumulator assembly from the case as a single unit.