Vehicle Trim Height Adjustment

1. Check for rear position sensor codes (C1762 and C1763). If codes are present, repair before continuing.
2. Vehicle must be on a level surface with doors closed and with no passengers or extra weight in car.
3. Connect scan tool to Data Line Connector (DLC).
4. Ignition "ON," engine off.
5. Check rear Continuously Variable Road Sensing Suspension (CVRSS)position sensor values using the scan tool to be sure they are within range. If not, check for bent CVRSS position sensor brackets or disconnected sensors.

Important: Do not sit in vehicle while performing trim set procedure.

6. Proceed per instructions on the scan tool readout.
7. When complete, remove the scan tool from vehicle.