Digital Cluster

Transmitter Programming

Before starting this procedure, BOTH transmitters must be present. Failure to program the transmitters to the proper numbers will render the RFA system inoperative. (If the customer uses only one transmitter on the vehicle, use this transmitter as both transmitter 1 and 2. This is not the normal situation.) A scan tool may also be used to program the RFA system.

Programming Transmitter

1. Press OFF and WARM on climate control panel simultaneously. The IPC will light all telltales, go blank, and then enter diagnostic mode.
2. Press FAN DOWN to scroll through system until RFA? is displayed, then press FAN UP.
3. Press FAN DOWN until RFA OVERRIDE is displayed, then press FAN UP
4. NO OVRD RF 500 displayed, then press FAN
5. When PGM FOBI SO1 is displayed press WARM button, 99 will be displayed in left upper comer of IPC just below odometer. System is now ready to program transmitter.

6. A. Press and hold the TRUNK button on transmitter.
B. While holding TRUNK button press the LOCK button an hold or one second.
C. Hold both buttons for a total of three seconds Locks cycle when programming is complete.
D. If transmitter is not programmed within 30 seconds after entering 99 override display system will default and you must start at step 5 to continue.

7. To program transmitter 2, press FAN UP. Display will show PGM FOB2 S02.
8. Follow steps 5 and 6 to program transmitter.
9. Press RECIRC or RESET to EXIT the system.