Key Reminder Switch: Service and Repair

NOTE: You may need to refer to Steering Column Repair Procedures for any associated or referenced procedures or for access to the component. Service and Repair




REMOVAL PROCEDURE





1. Loosen the set screw (1).
2. Release the locking tabs in order to remove the ignition switch (2) from the lock housing (3).

INSTALLATION PROCEDURE





1. Press the ignition switch towards the rear of the column until the locking tabs are fully engaged in order to install the ignition switch (1) onto the lock housing (2).
2. Tighten the set screw onto the lock housing (2).