Knock Sensor Module: Service and Repair

Knock Sensor Module Service:

Knock Sensor Module:

REMOVAL PROCEDURE

1. Remove the PCM from the vehicle. Refer to PCM Replacement/Programming.

2. Remove the two KS Module cover screws and the KS Module cover.

3. Grasp the KS Module tabs with your thumb and finger.

4. Squeeze the tabs together.

5. Pull the KS Module straight up.


INSTALLATION PROCEDURE

1. Remove the two KS Module cover screws and remove cover (if not previously removed).

2. Hold the KS Module with your thumb and finger.

3. Insert the KS Module straight down into the PCM through the access opening.

4. Press the KS Module firmly into the PCM connector.

IMPORTANT: Ensure there is a good seal between access cover (1) and the PCM (3).

5. Place the KS Module cover(1) on the PCM (3).

6. Install the two cover screws.

^ Tighten the cover screws to 5.1 N.m (45 lb. in).

7. Install the PCM. Refer to PCM Replacement/Programming.