Transmission Speed Sensor: Service and Repair

REMOVAL PROCEDURE





1. Raise the vehicle. Refer to Vehicle Lifting Points.
2. Support the vehicle with safety stands.
3. Remove the electrical connector at the vehicle speed sensor.
4. Remove the retaining bolt and the sensor.

INSTALLATION PROCEDURE





1. Install the vehicle speed sensor and the retaining bolt.
^ Tighten the bolt to 10 Nm (89 inch lbs.).

NOTICE: Refer to Fastener Notice in Service Precautions.

2. Install the electrical connector at the sensor.
3. Remove the safety stands.
4. Lower the vehicle.





5. Connect the battery negative cable assembly to the battery negative terminal.
^ Tighten the terminal bolt to 15 Nm (11 ft. lbs.).