Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensors Installation:

Removal Procedure

Notice: Numbers in text correspond to numbered components in image.

1. Raise the vehicle and support.

2. Remove the electrical connector at the crank sensor located on the front engine bank.

3. Remove the retaining bolt (1) and crank sensor (2 or 3).


Installation Procedure

1. Install the crank sensor (2 or 3) and the retaining bolt (1).

^ Tighten the retaining bolt to 10 Nm (89 lb in).

2. lnstall the electrical connector at the crank sensor.

3. Lower the vehicle.