Disassemble / Assemble Procedure

Disassemble Procedure

1. Note the position of the fuel sender strainer for installation (2).
2. Support the reservoir with one hand and grasp the fuel sender strainer with the other hand.
3. Pull the fuel sender strainer off of the fuel sender assembly.
4. Inspect the fuel sender strainer. If the fuel sender strainer is contaminated, the fuel tank should be cleaned. Refer to Fuel System Cleaning.
5. Discard the fuel sender strainer after inspection.
6. Disassemble the electrical connectors from the sensor assembly of the fuel pump and the cover assembly.
7. Disassemble the fuel level sensor assembly (3).

Assemble Procedure

1. Assemble the fuel level sensor assembly.
2. Assemble the electrical connectors to the fuel pump and the cover assembly.
3. Position the new fuel sender strainer (2) on the modular fuel sender and push on the outer edge of the fuel sender strainer until the fuel sender strainer is fully seated.