Door Window Switch
POWER WINDOW SWITCHPower Window Switch - Eldorado:
REMOVAL PROCEDURE
1. Use a 13 mm (0.5 in) wide, flat bladed tool in order to pry up on the rear edge of the trim panel.
2. Insert the blade 19 mm (0.75 in) into the door trim in order to engage the retention clip.
3. Firmly press the blade toward the switch plate (1) in order to disengage the clip.
NOTE: The retainer clip must be fully disengaged before the switch plate is removed. Otherwise, damage to the switch plate could result.
4. Pull the flat bladed tool upward while pressing firmly toward the plate.
5. Pull the plate from the trim panel.
6. Disconnect the electrical connectors (2).
7. Remove the switch plate (1).
8. From the back side of the switch plate, gently pry the tabs in order to release the window switch from the switch plate.
9. Remove the switch.
INSTALLATION PROCEDURE
1. Install the switch.
2. Press the switch into the switch plate.
3. Connect the electrical connectors (2).
4. Install the switch plate (1) by evenly setting the plate into the trim panel (3).
5. Press the plate (1) in order to engage the clips on both ends.