Rear Camber Adjustment

REAR CAMBER ADJUSTMENT
1. Loosen the front and rear inside control arm mounting bolts.

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Move the control arm (1) in order to change camber and set to the specification.
^ Tighten the control arm mounting bolts to 90 Nm (66 ft. lbs.).