Vehicle Ride (Trim) Height Specifications

D 29 mm (1.14 inch)
Z 50 mm (1.97 inch)
J 220 mm (8.66 inch)
K 214 mm (8.43 inch)
P 715 mm (28.15 inch)
R 709 mm (27.91 inch)
* All measurements are plus or minus 10 mm (0.04 in).
* Maximum variation side-to-side is 12 mm (0.05 in).


"D" Specification Measurement:

D Measurement:

Measure the clearances (D) between the centerline of the front inner bearing bushing bolt (3) and the centerline of the front outer bushing bolt (1) (this measurement should be taken on the front side of the rear suspension assembly).


"Z" Specification Measurement:

Z Measurement:

Measure the clearance (Z) between the centerline of the bushing bolt (1) and the lowest point on the ball joint (3) (excluding the grease fitting).


"J,K,P,R" Specification Measurement:

J,K,P,R Measurement:

Measure the clearances (J,K,P,R) between the underbody and the ground.