Rear Suspension

REMOVAL
1. Raise and support the vehicle.
2. Remove the tire and wheel assemblies.
3. Remove both link lower bolts.
4. Remove both link upper nuts.
5. Remove the stabilizer brackets.
6. Remove the insulators from the stabilizer shaft.
7. Lower the exhaust system at the rear. Support the exhaust system.
8. Remove the stabilizer shaft from the vehicle.





INSTALLATION
1. Install the stabilizer shaft into the vehicle.
2. Raise the exhaust system back into place.
3. Install the insulators to the stabilizer shaft.
4. Install the stabilizer brackets.
5. Install the link upper nut to both sides.
6. Install the link lower bolt to both sides.
^ Tighten the upper link nut to 52 Nm (38 ft. lbs.).
^ Tighten the lower link bolt to 60 Nm (44 ft. lbs.).
^ Tighten the stabilizer bracket bolt to 60 Nm (44 ft. lbs.).

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

7. Install the tire and wheel assemblies.
8. Lower the vehicle.