Without B9Q/V4U

REAR HUB/BEARING

REMOVAL
1. Raise and support the vehicle.
2. Remove the tire and wheel assembly.
3. Remove the caliper. Suspend the caliper.
4. Remove the rotor.
5. Remove the hub and bearing assembly.

INSTALLATION
1. Install the hub and bearing assembly.
^ Tighten the hub mounting bolts to 70 Nm (52 lb ft).

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the rotor.
3. Install the caliper and new caliper bracket mounting bolts.
^ Tighten the caliper bracket mounting bolts to 113 Nm (83 lb ft).
^ Tighten the parking brake cable bracket bolt to 43 Nm (32 lb ft).

4. Install the tire and wheel assembly.
5. Lower the vehicle.