Automatic Door Lock (ADL) Feature
PERSONALIZATION OF THE RKEThe automatic door lock feature enables under the following conditions:
^ The ignition switch is in the RUN position.
^ If any door is open
^ The vehicle shifts into the PARK position.
The BCM uses the signal from the receiver to either enable or disable the automatic door lock feature. Use one of the following two different ways to program the automatic door lock feature:
^ Use the option register (the dealership uses a scan tool to program the automatic door lock feature) to enable or disable the automatic door lock feature for two FOBs (1st design) or four FOBs (2nd design).
^ Perform the following steps to program the automatic door lock feature using the FOBs:
1. Ensure the ignition switch is in the RUN position.
2. Ensure the gear shift lever is in the PARK position.
3. Press the brake pedal for the entire duration of the procedure.
4. Press the transmitter UNLOCK button 4 times for about 1 second with less than 5 seconds between presses to disable the automatic door lock feature.
5. Press the transmitter LOCK button 4 times for about 1 second with less than 5 seconds between presses to enable the automatic door lock feature.
CENTRAL DOOR UNLOCKING FEATURE
The Body Control Module (BCM) controls the central door unlocking feature through the remote control door lock receiver. Central door unlocking allows the front doors and the rear doors to unlock with the use of the key in the driver side front door. Hold the key on the unlock position for more than 1.5 seconds to unlock the remaining doors.
ANTI-LOCKOUT FEATURE
The Body Control Module (BCM) inhibits the activation of the power door lock feature actuated by the power door lock button when the key is in the ignition cylinder and/or the ignition turns to the RUN position or the START position with any door open. Continuous actuation of the power door lock button for 3 seconds overrides this feature. The BCM continues to prevent door to lock upon wake-up by door lock command from the discrete input if all the conditions are met for anti-lockout. The anti-lockout feature takes precedence over the automatic door lock functions. The doors will not lock if the automatic door lock function is enabled when the anti-lockout feature is active with the gear selector out of the PARK position. The BCM shuts down after the door closes or the BCM shuts down after 10 minutes if the key is left in the ignition switch with the door left open. The outputs controlling the following functions de-energize at power up or during a running reset to prevent inadvertent locking of the vehicle doors:
^ The LOCK function.
^ The UNLOCK function.
^ The fuel filler door function.