Radio Replacement (With RPO Code D55)

REMOVAL PROCEDURE



1. Remove the console trim plate.
2. Remove the ashtray assembly.
3. Remove the Driver Information Center Switch (DIS).
4. Remove the fasteners (1) from the radio and heater/AC control assembly.




5. Disconnect the following components:
^ The electrical connectors (1, 2, 3)
^ The antenna coax cable (4)
6. Remove the radio and heater/AC control assembly.




7. If you are using an exchange radio, perform the following additional steps:
7.1. Remove the bracket fasteners (3).
7.2. Remove 2 brackets (2) from the sides of the radio and the control assembly.
7.3. Remove one 16-mm (0.63-in) plastic locating pin and clip stud from the rear of the radio.
7.4. Remove the driver information display switch bracket (1).

INSTALLATION PROCEDURE



1. If you are using an exchange radio, perform the following additional steps:
1.1. Install the driver information display switch bracket (1).
1.2. Install one 16-mm (0.63-in) plastic locating pin and clip stud to the rear of the radio.
1.3. Install 2 brackets (2) to the sides of the radio and heater/AC control assembly.

NOTE: Refer to Fastener Notice in Cautions and Notices.

1.4. Install the mounting bracket fasteners (3).

Tighten
Tighten the fasteners to 6 N.m (53 lb in).




2. Connect the electrical connectors (1, 2, 3).
3. Connect the antenna coax cable (4).




4. Install the radio and heater/AC control assembly to the IP.
5. Install the fasteners (1).

Tighten
Tighten the fasteners to 2 N.m (15 lb in).

6. Install the DIS into the console opening.
7. Install the ashtray.
8. Install the console trim plate.