67. Water Pump Installation

- Tools Required
- J 38816-IA Water Pump Remover/installer





1. Check water pump seal (2) in the water crossover (1) for tears or cuts. Replace the seal if necessary.
2. Place the water pump (3) in the J 38816-IA by indexing the tool into the water pump locking ears (4).
3. Install the water pump (3) into the water crossover (1) using the following procedure:
3.1. Index the pump locking ears with the tangs in the water crossover.
3.2. With the locking ears indexed, twist to lock the pump in place. Remove the tool.





4. Install the water pump cover and gasket.

Notice: Refer to Fastener Notice in Service Precautions.

5. Install the water pump cover bolts.
- Tighten the water pump cover bolts to 10 Nm (89 lb in).