Turn Signal & Multifunction Switch - Disassemble

DISASSEMBLY PROCEDURE
1. Remove the hazard knob.
2. Unscrew the tilt lever and remove.
3. Remove the turn signal switch, lever.
4. Remove the upper tilt head components.





5. Remove the round washer head screw (2).
6. Remove the flat head tapping screw (3).
7. Remove the signal switch arm assembly (4).
8. Remove the 3 pan head 6 lobed socket tapping screws (1).
9. Remove the turn signal switch assembly connector from the bulk head connector.





10. Attach a wire to the turn signal switch assembly connector. This will help make installation easier.
11. Remove the turn signal switch assembly.
12. Pull the turn signal switch assembly connector through the column.