43. Case Cover Assembly Installation

1. Inspect the case cover mating surfaces for nicks, burrs, or damage.





2. Inspect the mating surfaces and inspect the cooler fitting and inspect the seal for damage.





3. Install the new island gasket (43) and the new case cover gasket (44) over the dowel pins on the case. Pass the wiring harness through the large opening at the top of the case cover gasket. Make sure that the wiring harness remains under the gasket, except for the portion where the connectors are attached.





4. Install the case cover assembly (33). Pass the wiring harness assembly through the opening at the top of case cover. Do not pinch the wires.





5. Install the case cover bolts (45-50), and hand tighten the bolts.





6. Install the two checkballs (65).