Front Door Window Glass: Service and Repair

Door Window Replacement

Removal Procedure

Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
^ Air bag deployment
^ Personal injury
^ Unnecessary SIR system repairs
In order to avoid the above conditions, observe the following guidelines:
^ Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
^ If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

Caution: In order to prevent SIR deployment, personal injury, or unnecessary SIR system repairs, do not strike the door or the door pillar in the area of the side impact sensor (SIS). Turn OFF the ignition and remove the key when performing service in the area of the SIS.

Caution: When working with any type of glass or sheet metal with exposed or rough edges, wear approved safety glasses and gloves in order to reduce the chance of personal injury.

1. Disable the SIR system.
2. Remove the trim panel.
3. Remove the water deflector.
4. Remove the inner belt sealing strip.





5. Remove the front lower run channel.
6. Remove the 2 rivets (2) retaining the regulator sash to the window (1).
7. Remove the window (1) from the door.

Installation Procedure





1. Install the window (1) to the door from the outboard of the door frame.
2. Install the rivets (2) on the regulator to the window sash channel.
3. Install the front lower run channel.
4. Adjust the window as needed.
5. Install the inner belt sealing strip.
6. Install the water deflector.
7. Enable the SIR system.
8. Install the trim panel.