Doors: Service and Repair
REMOVAL PROCEDUREIMPORTANT: Mark the location of the door hinges (1, 3) on the door (2).
1. Remove the trim panel.
2. Remove the water deflector.
3. Disconnect all of the electrical connectors from the door electrical components.
4. Remove the rubber conduit from the door.
5. Disconnect the wire harness from the door.
6. While the door is supported, remove the hinge-to-door bolts (1, 3).
7. With the aid of an assistant, remove the door (2).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the door hinge (1, 3), using the aid of an assistant, position the door (2) to the body.
Tighten
Tighten the bolts to 48 N.m (35 lb ft).
2. Connect the wire harness to the door.
3. Install the rubber conduit to the door.
4. Connect all of the electrical connections to the door electrical components.
5. Install the water deflector.
6. Install the trim panel.
7. Adjust door if necessary. Refer to Door Adjustment