Lock Housing - Assemble

ASSEMBLY PROCEDURE





1. Lubricate the switch actuator pivot pin (2) with synthetic grease. Install the switch actuator pivot pin (2).
2. Install the pivot and pulse switch assembly (1) from the lock housing cover assembly.





3. Lubricate the dimmer switch rod actuator (3) with synthetic grease. Install the dimmer switch rod actuator (3) to the column housing cover end base plate (3).
4. Install the column housing cover end base plate (2) to the lock housing cover assembly (1).
5. Install the lock housing cover assembly (1).
6. Align the dimmer switch rod to the dimmer switch rod actuator (3).

NOTICE: Refer to Fastener Notice in Service Precautions.





7. Install 3 pan head 6-lobe socket tapping screws. Tighten the screws (1) at 12 o'clock position first, screw (3) at 8 o'clock position second, and screw (2) at 3 o'clock position third.
- Tighten screws in same order to 9 Nm (80 inch lbs.).





8. Install the column housing cover end cap (1).
9. Install the steering column pass key lock cylinder set.