Steering Wheel

REMOVAL PROCEDURE

- Tool Required
- J 1859-03 Steering Wheel Puller

1. Disable the SIR system.
2. Remove the inflatable restraint steering wheel module.
3. Remove the nut that secures the steering column shaft.





4. Use the J 1859-03 in order to remove the steering wheel.

INSTALLATION PROCEDURE
1. Feed the coil assembly lead through the slot in the steering wheel.
2. Install the steering wheel to the column shaft.

NOTICE: Refer to Fastener Notice in Service Precautions.

3. Install the nut in order to secure the steering column shaft.
- Tighten the shaft nut to 41 Nm (30 ft. lbs.).

4. Install the inflatable restraint steering wheel module.
5. Enable the SIR system.