Oil Pump Pipe and Screen Assembly Replacement

Removal Procedure





1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Drain the engine oil.
4. Remove the lower oil pan. Refer to Oil Pan Replacement (Lower) or Oil Pan Replacement (Upper).
5. Remove the oil intake pipe bolts.
6. Remove the oil intake pipe.
7. Remove the oil intake pipe 0-ring.
8. Clean the sealing surfaces.

Installation Procedure





1. Install the oil intake pipe 0-ring.
2. Install the oil intake pipe.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the oil intake pipe bolts.
Tighten the oil intake pipe bolts to 8 Nm (71 inch lbs.).
4. Install the lower oil pan. Refer to Oil Pan Replacement (Lower) or Oil Pan Replacement (Upper).
5. Lower the vehicle.
6. Refill the engine oil. Refer to Capacities -Approximate Fluid.
7. Connect the battery negative cable. Refer to Battery Negative Cable Disconnect/Connect Procedure.