Manually Controlled Functions
The following features apply to the Driver (1) and Passenger (9) Temperature control functions:
^ The driver and passenger temperature control knobs provide a Dual-Zone heating and cooling feature.
^ Depress the passenger knob to change the Dual-Zone mode to the Single-Zone mode. The driver side control overrides the passenger side control in all cases.
^ The temperature controls adjust by an open-ended potentiometer in 2°C increments between 16°C to 28°C and 3°c increments between 29°C to 32°C (Fahrenheit increments are in 1°F steps
The following features apply to the Defrost (3) control function:
^ Push the DEFROST button to deactivate the AUTO function.
^ The AUTO function brings the blower speed to speed three.
^ The AUTO function deactivates the recirculation mode.
^ Push the DEFROST button again to return the system to the previously set mode.
The following features apply to the Rear Heated Window (4) control function:
^ Press the rear heated window button to activate the electrically conductive grid lines bonded to the rear window to defog the surface.
^ The outside rearview mirrors also heat when the rear heated window function is activated.
The following features apply to the Auto (2) control function:
^ Press the driver side TEMP know to set the system to the AUTO mode.
^ The sensors provide input to the H-A/C control to maintain the desired interior temperature when the system is set.
The following features apply to the Off control function:
^ The off control function deactivates the HVAC system. The outside air temperature remains displayed.
^ The system attempts to maintain the previously set temperature without the use of the blower motor or the A/C.
The A/C Off (7) control function deactivates the A/C compressor.
The following features apply to the Fan Speed (5) control function:
^ The H-A/C control uses a resistor installed in the duct downstream of the blower motor to control the blower motor speed.
^ The resistor location promotes a cooling effect.
^ The manual fan speed change over-rides the AUTO setting.
The following features apply to the Recirc Air (8) control function:
^ The recirculation function closes off most of the entrance of outside air.
^ The recirculation function recirculates the interior air.
^ The recirculation function aids in the efficiency of the A/C system by using the cooler inside air instead of the warmer and the more humid outside air.
The Defog (6) control function splits the air equally between the defroster and the floor outlets
The Bi-Level (6) control function provides outside air flow to the panel with a split to the floor outlet. The Floor (6) control function provides 100% air flow to the floor outlet ducts.