C0587

Circuit Description
The LR damper actuator is controlled by the Electronic Suspension Control Module with a Pulse-Width Modulation (PWM) signal. Battery voltage is modulated (switched on and off) at a high frequency (2.0 kHz) by opening and closing the actuator circuit in the Electronic Suspension Control Module. By controlling the amount of current to the actuator, the Electronic Suspension Control Module can then control the damping force in the damper. A higher level of damping force is achieved by providing correspondingly higher current levels, relating to higher percentages of PWM duty cycle.
The default damper state (no battery voltage) is one that provides a minimum damping force.

Conditions for Running the DTC
^ The ignition is on.
^ The fault is detected during three consecutive ignition cycles, or during the same ignition cycle after clearing the DTC using the scan tool.

Conditions for Setting the DTC
The DTC is set when the Electronic Suspension Control Module measures a feedback voltage lower than a preset value during two consecutive OFF-state damper diagnostic test procedures.

Action Taken When the DTC Sets
^ The SERVICE RIDE CONTROL message will be displayed.
^ ALL damper actuators will be disabled by commanding 0 % PWM duty cycle (damper control switch open).
^ The vehicle speed will be limited.
^ The vehicle ride will be soft.

Conditions for Clearing the MIL/DTC
^ The scan tool can be used to clear the DTC.
^ The On-Board diagnostics CLEAR RSS CODES feature can be used to clear the DTC.
^ The DTC is saved as history when the Electronic Suspension Control Module no longer sees a short to ground on the damper low-side drive circuit. The DTC will clear if the fault does not return after 50 consecutive ignition cycles.

Diagnostic Aids
Refer to Testing for Intermittent and Poor Connections in Wiring Systems.

Test Description
The number(s) below refer to the step number(s) on the diagnostic table.
2. Listen.for an audible. click when the LR solenoid operates. Command both the ON and OFF states. Repeat the commands as necessary.
3. Tests for voltage at the coil side of the LR solenoid.
4. Verifies that the Electronic Suspension Control Module is providing ground to the LR solenoid.
5. Tests if ground is constantly being applied to the LR solenoid.






DTC C0587 Left Rear Solenoid Circuit Low