P1133

CIRCUIT DESCRIPTION

Engine Control Schematics: Heated Oxygen Sensors (HO2S):

The HO2S is a sensor used to detect oxygen-content in the exhaust. The PCM supplies the sensor with a signal circuit and a ground circuit. The PCM supplies a bias voltage between the circuits. The sensor varies the voltage based on the oxygen content in the exhaust. When the exhaust stream is lean (more oxygen), the sensor produces a low voltage signal. When the exhaust stream is rich (less oxygen), the sensor produces a high voltage signal.

The PCM monitors the HO2S sensor activity to make sure that enough lean to rich and rich to lean switches occur. A lean to rich switch occurs when the HO2S signal voltage changes from less than 300 mV to more than 600 mV. A rich to lean switch occurs when the HO2S signal voltage switches from more than 600 mV to less than 300 mV. The PCM counts the number of lean to rich and rich to lean switches for 100 seconds. If the PCM determines that HO2S bank 1 sensor 1 did not switch enough times, DTC P1133 will set.

CONDITIONS FOR RUNNING THE DTC
^ No TP sensor, MAF sensor, MAP sensor, IAT sensor, ECT sensor, EVAP system, EVAP control, AIR system, AIR control, fuel injector, fuel trim, EGR Flow, or system voltage DTCs are set.
^ The engine speed is between 1500 and 3000 RPM.
^ The MAF is between 15 and 35 gps.
^ The canister purge duty cycle is more than 20 percent.
^ The TP angle is more than 5 percent.
^ The system voltage is between 8 and 18 volts.
^ The coolant temperature is more than 50°C (122°F).
^ Closed loop fuel control is enabled.
^ The air fuel ratio is between 14.5 and 14.8

CONDITIONS FOR SETTING THE DTC
^ The PCM monitors less than 40 lean to rich switches, and less than 10 rich to lean switches.
^ The condition is present for a 100 second monitoring period.

ACTION TAKEN WHEN THE DTC SETS
^ The PCM illuminates the Malfunction Indicator Lamp (MIL) during the second consecutive trip in which the diagnostic test runs and fails.
^ The PCM stores the conditions present when the DTC set as Freeze Frame and Fail Records data.

CONDITIONS FOR CLEARING THE MIL/DTC
^ The PCM will turn the MIL OFF after the third consecutive trip in which the diagnostic runs and passes.
^ The history DTC will clear after 40 consecutive warm-up cycles have occurred without a malfunction.
^ The DTC can be cleared by using the scan tool Clear DTC Information function.

DIAGNOSTIC AIDS

NOTE: Refer to HO2S wire repair notice in Service Precautions.

If the condition is intermittent, refer to Intermittent Conditions in Symptoms. Intermittent Conditions

TEST DESCRIPTION

Steps 1 - 10:

The numbers below refer to the step numbers on the diagnostic table.
2. Testing if other possible causes of this DTC have already been diagnosed.
3. Diagnose other DTCs first because they may be the cause of this DTC setting.
4. With the engine running warm, coolant at least 85°C (185°F) and at fast idle, the oxygen sensor voltage should rapidly swing above 0.60 volt and below 0.30 volt.
6. Testing if the oxygen sensor voltage is swinging between rich and lean very slowly, or not at all.
9. Testing for causes of oxygen sensor failure. If the sensor is replaced without finding the cause of contamination, premature failure of the new sensor may result.