Cellular Telephone Module Replacement (UV8 W/O UE1)

REMOVAL PROCEDURE




1. Remove the rear storage compartment trim.
2. Remove the bay board fasteners (2).
3. Pull the bay board (1) away from the body and place the bay board (1) module side up in the rear compartment.




4. Disconnect the electrical connection (2) from the Cellular telephone module (Cellular Phone Interface Unit) (1).
5. Remove the Cellular telephone module (1) by releasing the tab and pulling Cellular telephone module from the lower mounting on the bay board.

INSTALLATION PROCEDURE




1. Install the Cellular telephone module (1) to the bay board
2. Push in on the top of the module (1) until an audible click is heard, indicating the module (1) is securely fastened to the bay board.
3. Install the electrical connection (2) to the cellular telephone module (1).




4. Install the bay board (1) to the vehicle body.
5. Install the bay board fasteners (2).

NOTE: Refer to Fastener Notice in Service Precautions.

Tighten
Tighten the fasteners (2) to 9 N.m (80 lb in).

6. Install the rear compartment trim.

For a description of the RPO Code(s) shown in this image/article refer to the RPO Code List found at Vehicle/Application ID RPO Codes