Night Vision Camera Replacement

REMOVAL PROCEDURE

IMPORTANT:
^ The night vision camera is not serviceable and must be sent to an authorized service center only.
^ If the night vision camera is removed or adjusted for any reason, it must be aimed. Refer to Night Vision Camera Aiming.




1. Open and support the hood.
2. Disconnect the night vision camera electrical connector.

IMPORTANT: Release retainers from the back side.




3. Turn the three camera retainers (1) 90 degrees and remove the camera from the mounting bracket.
4. Remove the camera assembly.

INSTALLATION PROCEDURE

IMPORTANT: Make sure the retainers are fully turned and in the locked position.




1. Install the night vision camera to the mounting bracket and turn the retainers (1) 90 degrees from the back side.




2. Connect the electrical connector.
3. Perform aiming procedure for night vision camera. Refer to Night Vision Camera Aiming.