CLOCK

To set the clock, press and hold the HR or MN button until the clock begins to change. Release the button as the display gets close to the correct time. Note that there is an initial two-second delay before the clock begins time-set mode. The clock stays on the display continuously.

The clock can also be updated by RDS data if the radio is tuned to an RDS broadcaster that send this information. Press the RDS SELECT button, followed by pressing and holding either the HR or the MN button. If the broadcaster is broadcasting the clock time data, the display should show STATION TIME IS_ :_ . The time will be what ever the broadcaster is sending. If the time is acceptable, simply continue to hold the HR or MN button until the display shows TIME UPDATED. If the broadcaster is not sending clock time data or the radio has not received the data, the display will show NO STATION TIME.

For a description of the RPO Code(s) shown in this image/article refer to the RPO Code List found at Vehicle/Application ID RPO Codes