Rear Seat Back Cushion Latch Cable Replacement

Rear Seat Back Cushion Latch Cable Replacement

Removal Procedure





1. Remove the rear seat back and disconnect the rear seat back pass through release cable (1). Refer to Rear Seat Back Replacement (1st Design ) (Rear Seat Back Replacement (1st Design )) in Seats.
2. Remove the tie strap securing the rear seat pass thorough release cable (1) to the seat back.
3. Remove the rear trunk trim. Refer to Rear Compartment Front Trim Panel Replacement (Rear Compartment Front Trim Panel Replacement) in Body Rear End.




4. Remove the nut (1) from the seat pass thorough release handle.




5. Remove the seat pass thorough release cable (2) and handle from the electrical component mounting panel (1).




6. Remove the cable housing (1) from the release handle housing (2) and slide the cable out of the lever in the handle.
7. Remove the release handle from the cable (1).



Installation Procedure





1. Install the seat pass thorough release cable (1) to the slot in the lever on the release handle (2).




2. Snap the cable housing to the release cable handle housing.




3. Install the pass thorough release cable (2) and handle through the opening in the electrical component mounting panel (1).




4. Partially install the rear seat back.
5. Connect the rear seat back pass through release cable (1).
6. Tie strap the pass through release cable (1) to the seat frame.




7. Install the rear seat back. Refer to Rear Seat Back Replacement (1st Design ) (Rear Seat Back Replacement (1st Design )) in Seats.
8. Install the release handle to the body.

Notice: Refer to Fastener Notice.

9. Install the release handle nut (1).

Tighten the nut to 9 N.m (80 lb in).

10. Install the rear trunk trim. Refer to Rear Compartment Front Trim Panel Replacement (Rear Compartment Front Trim Panel Replacement) in Body Rear End.