95. Accessory Installation
Drive Belt Tensioner Installation Procedure
1. Install the drive belt tensioner. Be sure to locate the tensioner anchor pin in the cylinder head recess.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the drive belt tensioner bolt.
Tighten the drive belt tensioner bolt to 50 Nm (37 lb ft).
Drive Belt Idler Pulley Installation Procedure
1. Place the drive belt idler pulley and bolt in position.
2. Tighten the drive belt idler pulley bolt.
Tighten the accessory belt idler bolt to 50 Nm (37 lb ft).
Air Conditioning Compressor Installation Procedure
1. Install the air conditioning compressor stud.
Tighten the air conditioning compressor stud to 25 Nm (18 lb ft).
2. Slide the air conditioning compressor over the air conditioning compressor stud and hold into position.
3. Install the air conditioning compressor side bolts finger tight.
4. Install the air conditioning compressor front bolt and nut finger tight.
5. Tighten the air conditioning compressor bolts and nut in the following sequence: 5.1. Tighten the air conditioning compressor front nut to 50 Nm (37 lb ft).
5.2. Tighten the air conditioning compressor front bolt to 50 Nm (37 lb ft).
5.3. Tighten the air conditioning compressor side upper bolt to 50 Nm (37 lb ft).
5.4. Tighten the air conditioning compressor side lower bolt to 25 Nm (18 lb ft).
Generator Installation Procedure
1. Place the generator in position.
2. Install the generator side bolts finger tight.
3. Install the generator front bolts finger tight.
4. Tighten the generator bolts in the following sequence:
^ Tighten the generator front upper bolt to 50 Nm (37 lb ft).
^ Tighten the generator side front bolt to 50 Nm (37 lb ft).
^ Tighten the generator side rear bolt to 50 Nm (37 lb ft).
^ Tighten the generator front lower bolt to 50 Nm (37 lb ft).
Power Steering Pump Installation Procedure
1. Place the power steering pump in position in the engine valley. Slide the molded wedge into the retaining feature cast into the cylinder block.
Important: You MUST push the power steering pump toward the rear of the engine as much as possible before tightening the bolt.
2. Install the power steering pump bolt.
Tighten the power steering pump bolt to 50 Nm (37 lb ft).