Daytime Running Lamp: Service and Repair

Daytime Running Lamps (DRL) Resistor Replacement




REMOVAL PROCEDURE
1. Remove left headlamp assembly.
2. Remove the retaining bolt.
3. Disconnect the electrical connector.
4. Remove the resistor (1).

INSTALLATION PROCEDURE
1. Install the resistor (1) to the vehicle.
2. Connect the electrical connector.

NOTE: Refer to Fastener Notice in Service Precautions.

3. Install the retaining bolt.

Tighten
Tighten the retaining bolt to 12 N.m (lb in).

4. Install the left headlamp assembly.