Outlet
REMOVAL PROCEDURETOOLS REQUIRED
J 37097-A Hose Clamp Remover/Installer
1. Drain the cooling system. Refer to Draining and Filling Cooling System in Cooling System.
2. Remove the air filter housing assembly.
3. Remove the heater hose from the heater outlet pipe (4).
4. Remove the hold-down fastener (5) from the heater outlet pipe (4).
5. Using the J 37097-A, remove the hose clamps from the hose on the thermostat housing and the surge tank hose.
6. Remove the surge tank hose from the heater outlet pipe (4).
7. Remove the heater outlet pipe (4) from the vehicle.
INSTALLATION PROCEDURE
1. Install the adapter hose to the thermostat housing end of the heater outlet pipe (4).
2. Install the heater outlet pipe (4) to the thermostat housing and place the hold-down bracket over the stud
3. Install the fastener (5) to the stud and hand tighten.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the surge tank hose to the outlet coolant pipe (4).
Tighten
Tighten the outlet coolant pipe fastener (5) to 25 N.m (18 lb ft).
5. Using the J 37097-A, install the hose to the thermostat housing and the surge tank hose.
6. Install the outlet heater hose to the heater outlet pipe (4).
7. Install the air filter housing assembly.
8. Fill the cooling system. Refer to Draining and Filling Cooling System in Cooling System.