Bank 2

REMOVAL PROCEDURE

Locations View:

1. Remove the engine sight shield retaining bolts and the engine sight shield.
2. Disconnect the ignition control module electrical connector.
3. Remove the engine oil level indicator.




4. Using the removal sequence, remove the ignition assembly retaining bolts.
5. Carefully, remove the ignition assembly.

INSTALLATION PROCEDURE

IMPORTANT: Be sure the ignition assembly grounding spring and insulator are in place when installing the ignition assembly.

Locations View:

1. Connect the spark plug boots to the spark plugs. Carefully, install the ignition assembly.

NOTE: Refer to Fastener Notice in Service Precautions.




2. Install the ignition assembly retaining bolts.

Tighten
Using the installation torque sequence, tighten the ignition assembly retaining bolts to 9 N.m (80 lb in).

3. Reconnect the ignition assembly electrical connector.
4. Install the engine sight shield and retaining bolts.

Tighten
Tighten the engine sight shield retaining bolts to 8 N.m (70 lb in).

5. Install the engine oil level indicator.