SIR Steering Wheel Module Coil - Disassemble

Disassembly Procedure

Important: Check the main wiring harness assembly for burned 2 amp fuses before doing this procedure.

1. Remove the upper and lower shrouds. Refer to Steering Column Trim Covers - Disassemble - Off Vehicle (Power Tilt/Telescope-Column Shift) or Steering Column Trim Covers - Disassemble - Off Vehicle (Power Tilt and Telescope, Floor Shift) or Steering Column Trim Covers - Disassemble - Off Vehicle (Manual Tilt, Floor Shift) or Steering Column Trim Covers - Disassemble - Off Vehicle (Manual Tilt, Column Shift).





2. Remove the retaining ring (2) using snap ring pliers.
3. Disconnect the SIR coil assembly (1) connector from the wire harness assembly.
4. Slide the SIR coil assembly (1) off of the steering shaft.