Shift Lever

Removal Procedure





1. Disable the SIR system. Refer to Disabling the SIR System in Air Bags and Seat Belts.
2. Remove the steering wheel, Refer to Steering Wheel Replacement.
3. Remove the steering column shrouds.
4. Disconnect electrical connector from traction control harness if equipped and feed harness out of column. Observe the harness routing and location to assist in reassembly.
5. Remove the TORX(R) head fastener from the shift lever to shift control.
6. Pull the shift lever upward to remove it from the shift control.

Installation Procedure





1. Push the shift lever downward to engage it into the shift control.
2. Install the TORX(R) head fastener.
3. Feed the traction control harness (if equipped) back through the column. Use care to route the harness as previously observed.
4. Install the steering column shrouds.
5. Install the steering wheel. Refer to Steering Wheel Replacement.
6. Enable the SIR system. Refer to Enabling the SIR System in Air Bags and Seat Belts.