Automatic Level Control Air Compressor Head Replacement
Removal Procedure1. Remove the air compressor assembly from the vehicle. Refer to Air Compressor Replacement
2. Remove the air compressor connector from the connector anchor (slide the air compressor connector away from the air compressor and off of the anchor).
3. Remove the three bolts and the heat shield from the air compressor bracket.
4. Remove the air dryer. Refer to Automatic Level Control Air Dryer Replacement.
5. Cut the harness tie.
6. Remove the bolt and the harness tie.
Important: Note the wire colors and the terminal numbers to ensure correct assembly.
7. Remove the two harness ties and the wrap from the wires.
8. Remove two wire terminals from the air compressor connector.
9. Remove the air hose from the air compressor head.
10. Remove the three head bolts and the air compressor head from the air compressor assembly.
11. Remove the gasket from the air compressor head or the air compressor assembly.
Installation Procedure
1. Install the new gasket on the air compressor assembly.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the air compressor head on the air compressor assembly with the three bolts.
Tighten the three bolts to 6 Nm (53 inch lbs.).
3. Connect the air hose to the air compressor head.
4. Install the two wire terminals in the air compressor connector.
5. Install the wrap around four wires and secure with two harness ties.
6. Install four wires in the harness tie and install the harness tie on the air compressor head with, the bolt.
Tighten the bolt to 3 Nm (26 inch lbs.).
7. Install the air dryer. Refer to Automatic Level Control Air Dryer Replacement
8. Install the heat shield and the harness tie on the air compressor bracket with the two bolts.
Tighten the bolts to 4 Nm (35 inch lbs.).
9. Connect the air compressor connector to the connector anchor.
10. Install the air compressor on the vehicle. Refer to Air Compressor Replacement.