Front Position Sensor Replacement - Electronic Suspension
Removal Procedure1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the wheel from the vehicle. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
3. Disconnect the height sensor connector.
4. Disconnect the sensor link from the ball stud (1).
5. Loosen the sensor mounting nut.
6. Remove the sensor from the vehicle.
Installation Procedure
1. Insert head of the sensor mounting stud into the key hole.
Notice: Refer to Fastener Notice in Service Precautions.
2. Tighten the sensor mounting nut.
Tighten the nut to 9 Nm (80 inch lbs.).
3. Connect the sensor link on the ball stud (1).
4. Connect the height sensor connector.
5. Install the wheel on the vehicle. Refer to Tire and Wheel Removal and Installation in Wheels, Tires and Alignment.
6. Lower the vehicle. Refer to Vehicle Lifting.