Window/Division Channel - Rear Door Stationary

REMOVAL PROCEDURE




1. Remove the water deflector.
2. Remove the inner belt sealing strip.
3. Remove the window.
4. Remove the two push pins (2) on either sides of the assembly (1).
5. Remove the rear window channel lower retaining bolt (1).
6. Grasp the front, lower end of the window run channel at the center pillar and pull out along the length of the header, stopping at the division post.
7. Grasp the top of the division post and pull forward, unseating it from the reveal molding.
8. Remove the assembly from the door in an upwards motion.

INSTALLATION PROCEDURE




1. Insert the division post into the door opening.
2. Push the assembly down until the upper assembly is past the flange, this will ensure that the outer sealing strip will be properly positioned.
3. Pull the assembly upward into the door flange, making sure the division post retaining bolt is aligned with the slot and the locator aligns with the notch in the doors flange.
4. Seat the run channel along the door flange.
5. Press in the two push pins (2).
6. Install the rear window channel lower retaining bolt (1).

Tighten
Tighten the bolt to 9 N.m (80 lb in).

7. Install the window.
8. Install the inner belt sealing strip.
9. Install the water deflector.