Throttle Position Sensor: Service and Repair

REMOVAL PROCEDURE




1. Remove the rear seat cushion.
2. Disconnect the negative battery cable.
3. Remove the nuts (2) from the intake manifold sight shield (1).




4. Remove the IAC electrical connector (1) from the IAC sensor (4).
5. Remove the TP Sensor electrical connector (2) from the TP sensor (3).




6. Remove the throttle body assembly (1).




7. Remove the TP sensor mounting bolts (3) from the TP sensor (2).
8. Remove the TP sensor (2) from the throttle body (1).
9. Discard the O-ring.

INSTALLATION PROCEDURE




1. Install the new O-ring on to the TP sensor.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the TP sensor (2) on to the throttle body (1)

Tighten
Tighten the TP sensor screws to 2.3 N.m (20 lb in).




3. Install the throttle body assembly (1).




4. Install the TP sensor electrical connector (2) to the TP sensor (3).
5. Install the IAC electrical connector (1) to the TP sensor (4).
6. Connect the negative battery cable.
7. Install the rear seat cushion.




8. Install the intake manifold sight shield (1) to the engine.
9. Install the intake manifold sight shield nuts (2) to the intake manifold (1).

Tighten
Tighten the intake manifold sight shield nuts to 3 N.m (27 lb in).

10. Perform the TP Sensor learn procedure.
10.1. Turn ignition switch to the RUN/ON position.
10.2. Wait 1 minute.
10.3. Turn ignition switch to the LOCK/OFF position.
10.4. Wait 15 seconds.