Headlamp: Service and Repair

REMOVAL PROCEDURE




1. Remove the upper filler panel.
2. Remove the cornering lamp assembly (2).




3. Remove the 3 bolts (3) retaining the headlamp housing (2) to the bracket.
4. Disconnect the electrical connector.

CAUTION: Halogen bulbs contain gas under pressure.Handling a bulb improperly could cause it to shatter into flying glass fragments.To help avoid personal injury:
^ Turn off the lamp switch and allow the bulb to cool before changing the bulb.
^ Leave the lamp switch OFF until the bulb change is complete.
^ Always wear eye protection when changing a halogen bulb.
^ Handle the bulb only by its base.Avoid touching the glass.
^ Keep dirt and moisture off the bulb.
^ Properly dispose of the used bulb.
^ Keep halogen bulbs out of the reach of children.

5. Partially remove the headlamp housing (2).




6. Remove the headlamp bulb (3) from the headlamp housing (2).


INSTALLATION PROCEDURE




1. Install the headlamp bulb (3) to the headlamp housing (2).
2. Connect the electrical connector to the headlamp.




3. Install the 3 bolts (3) in order to retain the headlamp housing (2) to the bracket.




4. Install the cornering lamp housing (2).
5. Install the upper filler panel.