Ignition Control Module Replacement - Bank 2

REMOVAL PROCEDURE

Locations View:

1. Remove the engine sight shield retaining bolts and the engine sight shield.
2. Disconnect the ignition control module electrical connector.
3. Remove the engine oil level indicator.




4. Using the removal sequence, remove the ignition assembly retaining bolts.
5. Carefully, remove the ignition assembly.




6. Remove the ignition control module retaining screws.
7. Remove the ignition control module.

INSTALLATION PROCEDURE

NOTE: Refer to Fastener Notice in Service and Precautions.




1. Install the ignition control module.

Tighten
Tighten the ignition control module retaining screws to 0.8 N.m (7 lb in).

IMPORTANT: Be sure the ignition assembly grounding spring and insulator are in place when installing the ignition assembly.

2. Connect the spark plug boots to the spark plugs. Carefully install the ignition assembly.




3. Install the ignition assembly retaining bolts.

Tighten
Using the installation torque sequence, tighten the ignition assembly retaining bolts to 9 N.m (80 lb in).

4. Reconnect the ignition assembly electrical connector.
5. Install the engine sight shield and retaining bolts.

Tighten
Tighten the engine sight shield retaining bolts to 8 N.m (70 lb in).

6. Install the engine oil level indicator.