Suspension Control Module: Service and Repair

Removal Procedure





1. Remove the rear compartment trim panel. Refer to Compartment Front Trim Panel Replacement - Rear in Body Rear End.
2. Remove the rear seat cushion. Refer to Seat Cushion Replacement - Rear in Seats.
3. Remove the rear seat back. Refer to Seat Back Replacement - Rear in Seats.
4. Disconnect the Electronic Suspension Control module connectors.
5. Remove the nuts from the electronics bay board.
6. Tilt the electronics bay board to access the Electronic Suspension Control module.
7. Remove the Electronic Suspension Control module from the electronics bay board.

Installation Procedure





1. Install the Electronic Suspension Control module in the right electronics bay.
2. Install the electronics bay board.

Notice: Refer to Fastener Notice in Service Precautions.

3. Install the nuts on the electronics bay board.
- Tighten two screws to 9 Nm (80 inch lbs.).
4. Connect the electrical connectors to the Electronic Suspension Control module.
5. Install the rear seat back. Refer to Seat Back Replacement - Rear in Seats.
6. Install the rear seat cushion. Refer to Seat Cushion Replacement - Rear in Seats.
7. Install the rear compartment trim panel. Refer to Compartment Front Trim Panel Replacement - Rear in Body Rear End.
8. Perform the Electronic Suspension Control Module Calibration. Programming and Relearning
9. Perform the Trim Height Adjustment. Refer to Trim Height Adjustment.